Energenie EGM-PWML Bedienungsanleitung PDF herunterladen (Seite 30)

EGM

PWM

LAN ENERGY METER WIT

H LAN INTERFACE

All brands and logos are registered trademarks of their respective owners

• To edit the LAN device, select it and click the Device settings button,

or just double click on the LAN device

• To remove the LAN device, select it and click the Del button in the

keyboard

If the status of EGM-PWM-LAN shows the device is not Connected -

it could be due to the following reasons:

• Incorrect IP/Port/Password specified in the Add LAN device window

• PC is not connected to the local network

• You are trying to access EGM-PWM-LAN from the PC which is not

allowed to do so. Change PC IP address or change IP filter list in

EGM-PWM-LAN hardware settings (see section 4.5 above)

• EGM-PWM-LAN is not connected to local network. To check if EGM-

PWM-LAN is on your local network you can do so-called ping test:

• Go to Start->Run

• Type cmd

• Type ping <EGM-PWM-LAN IP Address specified in utility>

in the window which would appear

Suppose EGM-PWM-LAN with IP address 192.168.2.189 is

connected to the local network. Then the cmd window will look as shown

on the Figure #14 below:

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Keine Kommentare

Energenie EGM-PWML Bedienungsanleitung Seite 30